Cleaning the Water Intake Filters

There is a filter at the end of each water intake valve at the rear of the product and also at the end of each water intake hose where they are connected to the tap. These filters prevent foreign substances and dirt in the water to enter the product. Filters should be cleaned if they are dirty.

  1. Close the taps.
  2. Remove the nuts of the water intake hoses to access the filters on the water intake valves and clean them with an appropriate brush. If the filters are too dirty, remove them from their places with a pliers and clean in this way.
  3. Take out the filters on the flat ends of the water intake hoses together with the gaskets and clean thoroughly under running water.
  4. Replace the gaskets and filters carefully and tighten their nuts by hand.