Installation Safety

• Check the information on the manual and installation instructions to prepare the product for installation and make sure the electrical mains, clean water mains and water outlet are suitable. If not, call a qualified electrician and plumber to have them make the necessary arrangements. These operations are the responsibility of the customer.
• Check for any damage on the product before installing it. Do not have the product installed if it is damaged.
• Injuries may occur if hands are put into uncovered slots. Close the holes of the transportation safety bolts with plastic plugs.
• Do not install or leave the product at locations where it may be exposed to external environment conditions.
• Do not install the product at locations where the temperature drops below 0 ºC.
• Do not place the product on a carpet or similar surface. It would create fire hazard since it cannot receive air from underneath.
• Place the product on a level and hard surface and balance with the adjustable legs.
• Connect the product to a grounding plug protected by a fuse suitable to the current values on the type label. Make sure the grounding is carried out by an expert electrician. Do not use the product without suitable grounding to local/national regulations.
• Plug the product in a socket with voltage and frequency values suitable to those indicated on the type label.
• Do not plug the product to loose, broken, dirty, greasy sockets or sockets that has come out their seats or sockets with a risk of water contact.
• Use the new hose set provided with the product. Do not re-use old hose sets. Do not make additions to the hoses.
• Connect the water inlet hose directly to the water tap. The pressure from the tap should be minimum 0.1 MPa (1 bar) and maximum 1MPa (10 bars). 10 to 80 litres of water should be running from the tap in a minute in order for the product to function properly. If the water pressure is above 1 MPa (10 Bars), a pressure-reducing valve should be fitted. The maximum allowed temperature is 25°C.

• Fit the end of the water discharge hose to the dirty water discharge drain, the sink or the bathtub.
• Place the power cable and houses in locations without risk of tripping.
• Do not install the product behind a door, a sliding door or at another location that will prevent the door from opening completely.
• If a drier is to be placed on the product, fix with a suitable connection apparatus obtained from the authorised service.
• There is a risk of contact with electrical pieces when the upper trays is removed. Do not dismantle the upper tray of the product.
• Place the product at least 1 cm away from the edges of furniture.