Antenna Settings for Digital Satellite Channels and Searching for Channels Automatically with DiSEqC 1.0/1.1

NOTICE

LNB settings described in the following section require significant expertise on satellite systems. Contact an expert about the subject.

Press the

to switch to the TV mode.

Press the

, select Source and press the

Select Satellite and press the

Press the

, select Settings and press the

Select Channels & Inputs option, and press

Select Channels option, and press the

Select Satellite and press the

Select Channel Installation Mode option, and press the

Select Satellite (Standard) if you are using an operator, select Satellite (Operator Mode), and press the

Press the

to return to the previous menu.

Select Channels option, and press the

Select Automatic Channel Scan option, and press the

Select Antenna Type option and press the

As per your current antenna type, select DiSEqC 1.0 or DiSEqC 1.1 and press the

DiSEqC 1.0: By using a satellite or switch, broadcasts can be received from up to four different satellites at the same time.
DiSEqC 1.1: By using a satellite or switch, broadcasts can be received from up to sixteen different satellites at the same time.

Depending on your selection of DiSEqC 1.0 or DiSEqC 1.1 ,4 or 16 satellites will be displayed in the menu.

Select a satellite from the Automatic Channel Scan menu and press the

Select the required options with the .

Satellite Status: Select On.
Satellite Selection: Press , select the satellite you want to search for and press the .
Scan Mode: Select Full or Network.
Scan Type: Select for unencrypted channels only Only Free Channels, encrypted channels only Encrypted Channels Only or for all satellite channelsAll.
Channel Store Type: Select for TV channels only Only Digital Channels, for Radio channels only Only Radio Channelsor for all channelsAll.

SelectLNB Settings and press the

Select the required options with the .

LNB Power: Press and select LNB powerOn then press .
LNB Frequency: Press and select LNB frequency used in the satellite system and press again the .

DiSEqC Port: Press

DiSEqC Port menu will be displayed.
To select the satellite corresponding to the relevant DiSEqC positions in the satellite system, select DiSEqC A, DiSEqC B, DiSEqC C or DiSEqC D.

If Antenna Type, DiSEqC 1.1 is selected, make a selection between Uncommit 1 andUncommit 16.

Return to the Automatic Channel Scan menu by pressing the

twice.

Make the settings described in steps 16 to20 for other three satellites you want to scan.

After completing the settings individually for all four satellites, from theAutomatic Channel Scan menuNext and press

Automatic Search menu will be displayed and the search for TV stations shall start.
Search may take several minutes depending on the number of television stations received.

Press

to return to the previous menu, press

to return to TV broadcast or press

to return to Home menu.