Using the Door Water Dispenser

After connecting your product to the water source or changing the water filter, flush the water system. Use a sturdy container to press and hold the water dispenser lever for 5 seconds, then release for another 5 seconds. Continue this cycle until water begins to flow. Once water starts flowing, continue pressing and releasing the water dispenser pedal (press for 5 seconds, release for 5 seconds) until you reach 4 gallons. 15 liters of water has been dispensed. This process purges the air from the filter and water dispenser system, preparing the water filter for use. Additional purging may be required in some homes. Water may gush from the dispenser as air is removed from the system.

Allow the product to cool for 24 hours and let the water cool. Remove enough water each week to ensure a fresh supply.

After continuously dispensing water for 5 minutes, the water dispenser will stop dispensing water to prevent overflow. To resume dispensing water, press the dispenser pedal again.

*Water fountain at the door

*Water Intake

When you press the pedal to turn on the water fountain, hold a container under the spout of the fountain.

Release the tap to stop drawing water.

It's normal for the first few glasses of water from the spring to be lukewarm.

Use only clean drinking water.

If the water fountain hasn't been used for a long time, pour out the first few cups of water to obtain clean water.

For the first use, you need to wait approximately 24 hours for the water to cool down.

Remove the glass a little while after pulling the trigger.

*Internal water dispenser

For using the water fountain

Before using your product for the first time and after changing your water filter, water may drip from the dispenser. To prevent water from dripping or leaking from the dispenser, purge 5-6 gallons (approximately 20 liters) of water from the dispenser before using your product for the first time and after each water filter change to remove air from the system. This removes trapped air and prevents the dispenser from leaking. If there is an obstruction in the water flow, the straightness of the water line and the coupling position at the back of the unit should be checked.

It's normal for your water dispenser to leak only a few drops of water after you've taken some.

If you haven't used the water dispenser for a long time, pour out the first few glasses of water to get clean water.