High temperature self-cleaning

The oven is equipped with a pyrolysis feature. The oven heats up to a temperature of approximately 420-480 °C and burns until the existing dirt turns to ash. A strong smoke may be generated. Provide good ventilation. High-temperature cleaning should be performed after approximately every 10 uses of the oven.

General warnings

DANGER

Hot surfaces cause burns!

Do not touch the product during self-cleaning and keep children away from the product. Wait at least 30 minutes before removing the residue.

Before using the pyrolysis function, remove all accessories, the telescopic shelf and the side shelves (if any). If not removed, the accessories and side wire shelves will be damaged.
If your product has a pyro proof accessory (resistant to high temperature self-cleaning), you do not need to remove these accessories from the oven. Whether your accessories are pyro-proof or not is specified in the accessories section. If not specified, your accessories are not resistant to high temperatures. It must be removed from the oven before cleaning to avoid damage.
Do not clean the door seal. The glass fiber seal is very delicate and easily damaged. If the door seal is damaged, replace it with a new one from an authorized service.

To start the pyrolysis function:

Remove all accessories inside the oven. In the models with wire shelves, remember to remove the wire shelf.

Before starting the cleaning, clean the outer surfaces of the oven and the food residues inside the oven with soapy cloth.

Select the “pyrolysis” (Pyrolysis) function.

The “P2:00” flashes on the display. If your appliance is equipped with the Eco pyrolysis function, the “Pro” message is displayed on the display for 2 seconds first, and then the P2:00 message starts to flash.

NOTICE

If the “Pro” and then the “ECO” messages are not shown on the display, your appliance is not equipped with the Eco pyrolysis function.

Turn the temperature knob to the highest "max" (maximum) temperature.

When the pyrolysis function starts, “P2:00” lights up and starts counting down. The pyrolysis time (2 hours) is shown on the display. This time is unchangeable.

When the oven reaches a certain temperature after the pyrolysis process starts, the

symbol appears on the timer display and the oven door cannot be opened. Do not force the handle to unlock the door until the cleaning process is finished and the lock symbol disappears from the display.

When the cleaning process is finished, "End" appears on the display.

After "End" appears on the display, turn the function and temperature knobs to 0 (off) position to end the process.

When the

symbol disappears on the display, remove the remaining deposits with vinegar water.

Touch any key to stop the audible warning.

NOTICE

After the pyrolysis function is completed, the door lock will be active until the oven cools to the appropriate temperature. If you want to cook at this time, "H” will appear on the display and cooking will not be possible.

Self cleaning function with high temperature – Eco pyrolysis (It varies depending on the product model. It may not be available on your product.)

If your oven is not very dirty, we recommend using the "Pyrolysis - economy mode" function. "Pyrolysis - economy mode" function takes less time than the Pyrolysis" function. If the oven is very dirty, the "Pyrolysis - economy mode" function may not be sufficient. In this case, clean it by the "Pyrolysis" function.

Remove all accessories inside the oven. In the models with wire shelves, remember to remove the wire shelf.

Before starting the cleaning, clean the outer surfaces of the oven and the food residues inside the oven with soapy cloth.

Select the “pyrolysis” (Pyrolysis) function.

The “P2:00” and “Pro” message is shown on the display for approx. 2 seconds and then the P2:00 message starts to flash.

Tap the

key.

The “ECO” message is shown on the display for approx. 2 seconds and then the P1:30 message starts to flash.